Passage III

An RC circuit contains a resistor, a capacitor, and an input voltage source. Some students studied RC circuits containing a source of AC (alternating current) voltage. Frequency, in hertz (Hz), is related to the number of times/sec the highest voltage is attained. The measured input voltage from the AC source was the same in Studies 1-3.

Study 1

A circuit was assembled using a 1,000 Ω (ohm) resistor, a 1 microfarad capacitor (microfarad [μF] is a unit of capacitance), 2 voltmeters for measuring output voltages, and an AC input voltage source (see Figure 1).

The students varied the frequency of the input voltage and measured the output voltage, the voltage across the resistor or the capacitor. At each frequency, they calculated the gain, the ratio of the measured output voltage to the measured input voltage. The results are shown in Table 1.

Study 2

The students replaced the 1,000 Ω resistor with a 10,000 Ω resistor and repeated the procedure used in Study 1. The results are shown in Table 2.

Study 3

The students used a 10 μF capacitor and the 10,000 Ω resistor and repeated the procedure used in Study 1. The results are shown in Table 3.

16. An amplifier produces a measured output voltage that is greater than the measured input voltage. Did the RC circuits used in the 3 studies amplify the input voltage at any of the frequencies tested?

Answer and Explanation

Your Answer is

Correct Answer is H

Explanation

Look at the third and fourth lines of the paragraph below figure 1. They calculated the gain, the ratio of the measured output voltage to the measured input voltage. That is to say, when the gain is 1, output=input; when the gain is less than 1 When, output

Looking at tables 1-3, all gains are less than or equal to 1, that is to say, the output is not larger than the input, so the amplifier is not used, choose no